HurricaneShield Series

Pella HurricaneShield Vinyl Fixed (Picture)

Pella's Florida-built residential vinyl impact line for HVHZ installations.

Vinyl impact picture window built in Ocala by the CWS subsidiary, maximizing daylight on a 3-inch frame. LMI for HVHZ.

Impact Rating LMI Design Pressure +66.5/-66.5 psf Energy Made in USA

Impact protection, built for South Florida

The HurricaneShield Fixed is Pella's vinyl impact picture window, built on a 3-inch frame depth at the CWS Ocala facility. Maximizes daylight and view without operating hardware, LMI impact-rated for HVHZ Florida installations.

  • Vinyl frame engineered for strength and durability
  • Large-missile impact-rated laminated glass
  • Energy-efficient Low-E insulated glass options to control heat gain
  • Professionally installed across South Florida by Armor Pro
Configurations X = operable panel (it opens) · O = fixed panel (doesn’t open). Panels read left‑to‑right as viewed from outside (hung windows read top‑to‑bottom). Example: XO = operable on the left, fixed on the right.
Rectangle (Single)
Grille Styles
3/4" Contour Grilles-Between-the-Glass5/8" Flat Grilles-Between-the-Glass1" Contour Grilles-Between-the-Glass7/8" Contour Exterior Applied Grille with Grilles-Between-the-Glass
Impact Protection
Tested to withstand hurricane wind-borne debris
Engineered Strength
Built and tested to Florida product-approval standards
Energy Efficient
Low-E insulated glass options reduce heat gain
Limited Warranty
Manufacturer warranty plus Armor Pro install workmanship

At a Glance

Frame Material Vinyl
Max Size 84 x 96 in
Design Pressure +66.5/-66.5 psf
U-Factor 0.24–0.49
SHGC 0.15–0.53
Visible Trans. 0.32–0.63

Sizes & Pressures

Configuration Min size Max size Design pressure
Rectangle (Single) 9.75 x 15.75 in 84 x 96 in +66.5/-66.5 psf
2-Wide Composite w/ Integral Mullion 20.875 x 15.75 in 108 x 108 in +66.5/-66.5 psf

Glass & Energy Performance

Glass packageU-FactorSHGC VT CR
SunDefense Low-E IG - Impact Laminated (7/8in, Awn/Csmt profile)0.2650.235 0.53 57
Advanced Low-E IG - Impact Laminated (7/8in, Awn/Csmt profile)0.2750.31 0.58 56
Turtle Glass IG - Impact Laminated (7/8in, Awn/Csmt profile)0.2650.155 0.32 56

U-Factor / SHGC shown without grids; add-grid values vary slightly. Confirm exact ratings for your opening at quote.

Performance Certifications

Energy-performance data on file (manufacturer-published; not third-party certified).

Options

Frame finish
White Interior/White ExteriorBronze Interior/Bronze ExteriorWhite Interior/Bronze Exterior
Glass tint
Advanced Low-ETurtle GlassSunDefense Low-EAnnealed glassTempered glassObscure glassNeat glassBronze TintGray TintBlue Tint

Ready to install the Pella HurricaneShield Vinyl Fixed (Picture)?

Armor Pro measures, permits, and installs it across South Florida — code-compliant and warrantied. Get a free, no-obligation estimate.

Frequently Asked Questions

The HurricaneShield Fixed is Pella's vinyl impact picture window, built on a 3-inch frame at Pella's CWS facility in Ocala, Florida. It has no operating hardware, so it maximizes daylight and view, and we install it where you want a large unbroken pane that doesn't need to open. It comes as a single rectangle or as a 2-wide composite with an integral mullion.

Yes. The HurricaneShield Fixed is LMI impact-rated and HVHZ-approved, so it can be installed in the High-Velocity Hurricane Zone covering Miami-Dade and Broward. Because it's a fixed unit with no operating vent, it reaches a strong design pressure for its size. We confirm the specific approval and rating that applies to your opening at the time of quote.

The single rectangle goes up to 84 by 96 inches and up to 36 square feet, while the 2-wide composite with an integral mullion reaches 108 by 108 inches and up to 48 square feet. Both configurations are rated to a design pressure of +66.5/-66.5 psf. We size the window to your rough opening and confirm the rating against the wind load required at your address.

The picture window is the most efficient unit in the HurricaneShield line, with a U-factor as low as 0.265 on the SunDefense and Turtle Glass packages and a low end of 0.24 across the model. SunDefense runs SHGC 0.235, Advanced Low-E runs SHGC 0.31 for more visible light, and Turtle Glass runs SHGC 0.155 for coastal lighting rules; all use a 7/8-inch laminated impact glass unit on the awning/casement profile. We'll help you pick the glass that fits your sun exposure and any local ordinance.

The picture window is available in White interior/White exterior, Bronze interior/Bronze exterior, and White interior/Bronze exterior. Grids are optional, including 5/8-inch flat, 3/4-inch and 1-inch contour grilles-between-the-glass, and a 7/8-inch contour exterior-applied grille combined with grilles-between-the-glass. Because it's a fixed unit, it has no operating hardware or screen.

Yes. The Fixed is one of seven styles in Pella's HurricaneShield line, which also includes single hung, casement, awning, and sliding windows, so we commonly pair a large picture window with operating units to get both light and ventilation. The Fixed itself is offered as a single pane or a 2-wide composite. Armor Pro provides a free estimate and lays out the combination that fits your wall and your view.

Yes. HurricaneShield is Pella's dedicated residential vinyl impact line, built in Ocala, Florida for the HVHZ and certified for Miami-Dade and Broward across single-hung, casement, awning, sliding, and fixed windows plus hinged, sliding, and multi-slide patio doors. It carries Florida Product Approvals on each operation style. We confirm the specific approval against your opening size and configuration before ordering.

Impact windows use laminated glass with a tough interlayer that holds together when struck, so the opening stays sealed against wind and debris without shutters, meaning no plywood and no closing panels before a storm. HurricaneShield's ratings run high for vinyl, with the single-hung reaching up to 67.5 psf positive and 100 psf negative and the multi-slide patio door reaching up to roughly 80 psf. The exact rating depends on the size and configuration, which we confirm on the quote.

Pella Corporation is a family-owned national manufacturer headquartered in Pella, Iowa, founded in 1925 and now spanning more than 20 plants across the country. For the Florida hurricane market the important detail is that Pella's impact lines, HurricaneShield and Defender, are built in Ocala, Florida by Pella's CWS subsidiary, so the storm products are made in-state rather than shipped in. We install and service Pella across South Florida and handle the order, permit, and installation regardless of which plant a given product comes from.

Protect your home with Armor Pro Windows & Doors!

Call (954) 231-7164 or Get Started Online with a Free Estimate!